Impeller hub is made from the hub of a plastic Plantraco tri-turbo fan prop. Impeller blades made from the thin, wooden insert in the cigar tube, CA’d with 3/4 oz. fiberglass cloth. Wrapped on a cylinder and cut at angles like making twisted blades of a prop for rubber powered stick models. What do ya’ll think?
Bob Kreutzer’s MQ-9, as documented in previous issues of the newsletter, is nearly ready to take flight. I don’t think he has […]
By Jovi Murek Hello again, well I’m back at it and building up the DC-3 Wing for this chapter. In this step, […]
A Forty Size (Test Bed) Standard Electric RC Airplane By Carl Murphy Introduction This article begins where all the rest of the […]
Bill Allen has been a club member since the 90s and loves delta wing jets. He’s made the coolest jets from some […]
